Board:
3.3V LOGIC .BINSTM32F401RET6•84.0 MHz
ONLINE
Initializing Circuit Simulation Engine...
Properties Inspector
No Component Selected
Click any part or jumper wire on the canvas to inspect its parameters, or switch to Circuit & Env.
Logic Supply Voltage5.0V
Ambient Temperature25°C
-20°C (Freezing)25°C (Room)60°C (High)
Ambient Light Level500 Lux
0 Lux (Dark)500 Lux (Lab)1000 Lux (Direct)
Default Wire RoutingPhysical
Default Wire Thickness3.5px
GPIO Pin LEDs
Live LED light indication on all GPIO pins across all simulation boards.
LED Color Themegreen
Grid Snapping
Virtual Serial Monitor UART 9600
Virtual UART Serial ready. Output from Serial.print() will appear here.
Load Custom Firmware (.hex / .bin / .uf2 / .elf)AVR / ARM / RV / XT / MIPS
Drop compiled .hex, .bin, .uf2 or .elf here
or click to browse local filesystem
Loaded Binary Telemetry
Architecture:AVR ATmega328P
Clock Rate:16.000 MHz
Logic Voltage:3.3V Logic
Flash Used:32 KB
RAM Size:2 KB
Format:Intel HEX Default
Target Board:
3.3VSTM32F401RET6•84.0 MHz•512KB Flash
Toolchain:arm-none-eabi-gcc 12.3.1 (GNU)
SDK Template:
Project Files
.c / .h
Flash (ROM):17826 B / 512 KB
SRAM (RAM):7176 B / 96 KB
sketch.ino
10:03:46 PMEltroNerd Embedded Cloud Compiler & Simulator Environment Ready.
10:03:46 PMActive Toolchain: avr-gcc 12.1.0 (GNU) | Target: Arduino Uno R3 (ATmega328P)
10:03:46 PMSelect a board, write or edit your sketch, and click 'Build' or 'Compile & Simulate'.
sketch.inoC++ / Arduino
inosketch.ino
Sample Code:
Virtual Serial Monitor UART 9600
Virtual UART Serial ready. Output from Serial.print() will appear here.